Do you know how to install a weighing scale correctly?
1. Compact the soil, compact the sand and gravel, and apply the concrete as it is poured. The base is on the same horizontal surface layer, with an error not exceeding 2mm. The base is ensured by secondary grouting, and the tensile strength of the longitudinal load-bearing steel bars in the base should exceed 60% as much as possible to make it a grounding grid. Basically, try to ensure firmness, level and tidy, and prepare drainage pipes.
2. Lift the electronic device weighing scale section by section into the high support mold, and be sure to ensure safety. There is no need to stand under the lifted food. When the electronic device weighing scale quickly touches the ground, it can be adjusted slightly. Place the scale on a scale with four sensors. In addition, place the sensors in reverse position with embedded parts, fix the iron ball with an iron face, and plug the power plug into the sensor position hole to ensure that the sensor area is fixed properly.
3. After placing the scale, mark the wires as well, which is beneficial for identifying which sensor to use. Drag the wires to a special location for placement. After dragging all the power lines of the sensors to the position of the power box, the positions on both sides of the power box corresponding to the power lines of the sensors on both sides of the weighing body based on the error value mentioned earlier are beneficial for subsequent inspection, maintenance, and upkeep.
4. Cover the electronic device weighing scale and calibrate it to determine if it is flat. First, jump around the corners of the electronic device weighing scale to see if there is no sound or if there are slight fluctuations up and down. You can also use your hand to hold the stainless steel bearing and rotate it downwards. If it can be rotated, you can confirm that the electronic device weighing scale is not flat enough and can be scraped flat with a carbon steel plate. The force at each point can be detected by an inspection instrument. If the force is balanced, it indicates that the electronic device scale is in square meters.
Your message must be between 20-3,000 characters!